Air purifier maintenance makes edible fungus disease no problem

　　The multifunctional medical air disinfection machine adopts circulating wind ultraviolet disinfection, which physically filters out dust and microorganisms in the air, and cooperates with high-intensity ultraviolet rays to disinfect the air, while effectively preventing the influence of dust on the radiation intensity of the ultraviolet lamp tube, combined with a filter , Electrostatic adsorption dust removal and sterilization and negative ions to freshen the air to achieve sustainable disinfection of indoor air. The ultraviolet radiation intensity in the machine is as high as 10000uw/cm2. During the working process of the machine, the high-intensity ultraviolet rays inside the machine are sealed in the air duct of the disinfection machine. The medical air disinfection machine will not cause damage.

　　First of all, you must read the manual carefully before using it and fully understand the precautions. Whether it is used for static disinfection or dynamic disinfection, doors and windows must be closed. It is strictly forbidden to cover or block the air inlet and outlet of the equipment to avoid affecting the air circulation. At the same time, pay attention to the indoor environmental hygiene, keep the surface of the object clean and dust-free, including the top of the instrument cabinet and the countertop, and avoid secondary dust caused by the disinfection machine turning on the circulating air. Secondly, check the working status of the disinfection machine regularly. If you find that the lamp tube is not bright, the filter is damaged, etc., you should repair it immediately. Fault maintenance should be recorded.

　　Maintenance and maintenance of multifunctional air disinfection machine

　　1. Cabinet: Keeping the cabinet clean can reduce indoor air pollution sources. Wet-wipe and clean the surface of the case regularly, and clean and disinfect it at any time when it is contaminated. Pay special attention to the air inlet and outlet when cleaning.

　　2. Filter: The cleanliness of the filter is related to the frequency of use of the disinfection machine and air quality. In the case of high frequency of use and poor indoor and outdoor air quality, the filter is more likely to accumulate dust and dust. Therefore, the filter should be checked regularly If dust is found on the net, it should be cleaned with a soft brush. If the time is too long, rinse it with water or a neutral wall-mounted disinfector cleaner. If the filter is damaged and aging, it should be replaced in time. When it is suspected that the use site is seriously polluted, the frequency of inspection should be increased.

　　3. High-intensity ultraviolet lamp: The filter at the air outlet of the disinfection machine has a protective effect on the ultraviolet lamp. The circulating air entering and leaving the machine is relatively clean. Therefore, cleaning the filter is far more important than wiping the lamp. If you find dust in the lamp, wipe it with 75% alcohol to ensure that the radiation intensity of the lamp is not affected by the dust. The radiation intensity of ultraviolet light is the key to killing bacteria. Therefore, the radiation intensity of the ultraviolet lamp in the machine should be monitored every six months. When the radiation intensity is lower than 6000uw/cm mobile disinfection machine2, the lamp should be replaced in time to Ensure the disinfection effect.

Read recommendations:

F19 Cooling Fan

A20 Aroma Diffuser

Can a humidifier and an air purifier be used together?

F11 Cooling Fan

aromatherapy diffuser Factory