Installation and location selection of wet film humidifier.Humidifier manufacturer

　　The installation position of the equipment can be selected according to the following factors:

　　① The relative humidity of the required humidifying environment. In the required humidifying environment, when the relative humidity is higher than 75% RH, the humidifying equipment shall be installed outside the required humidifying environment; When the relative humidity is lower than 75% RH, the humidification equipment can be installed in the humidification environment.

　　② Explosion proof requirements for the required humidification environment; All explosion-proof requirements for the required humidifying field, and the humidifying equipment shall be installed in the non explosion-proof area outside the required humidifying environment.

　　③ If the Celsius temperature in the required humidification environment is lower than zero, the equipment shall be installed in a place where the Celsius temperature is higher than zero outside the required humidification environment.

　　④ If there is a lot of floating dust in the required humidification environment, which may cause the equipment to have poor air intake, the equipment shall be installed outside the required humidification environment.

　　After the equipment installation position is determined according to the above conditions, the equipment installation height should also be considered. In general, the equipment mist outlet port should be set at the upper end of the humidification site, within 50cm from the top, and the vertical distance between the mist outlet port and the equipment should be reduced as far as possible to maximize the gas mist transmission efficiency. Therefore, the atomization and humidification equipment should be installed at a high position as far as possible.

　　After the installation site and installation height of the equipment are selected, the mist outlet pipeline can be connected according to the specific conditions in the humidification site: first, if there is a high-speed air flow source in the humidification site, such as various high-speed fans, various gas injection ports, etc., the port of the mist outlet pipeline should be set below the air flow source, and the outlet should be upward, so that the high-speed air flow source can be used for uniform gasification and diffusion; If the air flow is relatively static in the humidification site, it is necessary to consider extending the fog outlet pipeline in the humidification site, evenly distributing the fog outlet ports, and forming an angle of 30 degrees between each fog outlet port and the horizontal, so that the humidification water mist can float and gasify naturally.

Read recommendations:

K6 portable air purifier Car Air purifier

H03 Heater Fan

What factors affect the effect of air purifiers.air purifier covid

aromatherapy diffuser sales

ultrasonic aroma diffuser